Finally started the Flame Job. Not bad only about two hours. Now if the rain will just stop so I can try it again.
Detail of the Flame Job, would have had a few wrinkles to straiten, but overall I was impressed with the results for a first try.
But as you can see the metal was a little too rusty and ripped.
This is the Embossing Bench I made up, just a couple of pieces of steel set on some cement blocks. The thin piece of tin is just for indexing, so I can see where the step is in the Bench as I turn the metal.
A detail of the Embossing Tool I made up, just a couple of pieces of steel welded together, one side left flat, the other ground in a curve.